Job Description (JD)
| Nama Program | OPERASI PEMBAGASAN DAN PENGECATAN [F433-004-2:2018] |
|---|---|
| Kod CU | F433-004-2:2018-C03 |
| Competency | Core |
| Tajuk CU | 3. Abrasive Blasting Operation |
| Penerangan CU | Abrasive Blasting Operation describes the surface preparation method by cleaning surfaces under high pressure streams to remove contaminants or paint before applying a protective coating on the surface. The procedure method for applying abrasive blasting can be either dry or wet. The choice of abrasive media type and the required equipment depends essentially on the nature of surface to be cleaned. The personnel who is competent in this CU shall be able to interpret blasting Job Safety Analysis or Permit To Work, inspect blasting media, set up blasting equipment, carry out blasting equipment servicing, perform blasting activity and perform blasting finishing and small repairs. As the abrasive blasting operation involves handling of high pressurised equipment, the job safety procedures always are being highlighted to minimise potential safety and health hazards at work. The outcome of this CU is the abrasive blasting operation are completed and meet the standard blasting specifications according to job requirements with awareness on health, safety and environmental requirements. |
| Tempoh Latihan | 140 |
| Objektif Pembelajaran | The outcome of this competency unit is able to perform abrasive blasting operation with awareness on health, safety and environmental requirements. Upon completion of this competency unit, trainees shall be able to: 1. Interpret Blasting Job Safety Analysis or Permit To Work 2. Inspect blasting media 3. Set up blasting equipment 4. Carry out blasting equipment servicing 5. Perform blasting activity 6. Perform blasting finishing and small repairs |
| Pra-Syarat | 0 |